| |
This lipo tray was designed and tested on the following lipo batteries
Orion 3200 / 3600 / 3800
IP 3800 35C
3Racing 3700
SMC 4000
Measurements
Size of the pockets for the humps are .500 inches x .360 inches x .070 deep
Pocket centers are .915 inches along the length and 1.285 inches along the width
Overall size: 5.400 inches x 1.954 inches x .250 inches thick (total thickness)
Size of Battery Slot Tabs: 0.650 inches wide 1.835 long x 0.080 inched deep
Spacing of Battery Slot Tabs: 0.915 inches
Max Width for Lipo Battery being used: 1.850 inches
Max Length for Lipo Battery being used: none
Max Height for Lipo Battery being used: Tray adds 0.050 inches
Comments
- tray is centered on frame cutouts, and should still allow the use of the tape slots
- tabs are machined slightly smaller than the slots in the chassis, but
due to variations in manufacturing (of the chassis and/or battery tray), it may be
necessary enlarged the cutouts in the chassis slightly with small grinder
- it will be necessary to grind some material off of the bottom front side of the right
head. This amount will vary with the height of the battery being used
|
|
